Barbieri Electronics

Updated on Jul 03, 2020

Barbieri Spectro LFP qb - Measurement ends and the process is aborted

Problem Description

The Barbieri Spectro LFP qp measurement device is controlled by the Workflow via an Ethernet connection.

The Calibration chart is correctly aligned using the alignment marks on the measurement table.
The measurement process is started in the Workflow.
The measurement device starts to move down the horizontal and vertical alignment bars and returns to the original position to perform the calibration measurement steps.
After calibration is complete, the measurement device resets itself and the process is aborted.

Solution

First check whether the measurement process via USB is working properly. If the measuring device does not work via the Ethernet connection, proceed as follows:

Check the Gateway Software version

Open Barbieri Gateway and make sure you are using the most recent version of the Gateway Software. The following versions are currently available here:

Operating System	Software Version
Mac OS (10.10 - 10.15) Catalina	Gateway 4.5
Mac older versions	Gateway 4.4
Windows (64 bit)	Gateway 4.5
Windows (32 bit)	Gateway 4.5

Check the current firmware version of your device as follows:

Open the Barbieri Gateway Software
Click on the Settings button [1] in the menu to the left
Under the Communication Port drop-down menu [2] make sure that USB is selected (this is important because updating the Firmware regardless of the type of device must be carried out using the USB connection).
Under the Instrument Connection Type drop-down [3] make sure that Direct USB is selected.
Take a look at the current Firmware Version in the footer of the Gateway Software [4]